Honda Crank Bearing Press Tool measurements, dimensions - CX500, GL500, CX650, GL650

Before using this site please read the site disclaimer. Also please note that any links provided may be part of an affiliate programme (viz. eBay, Amazon) which helps support the site as I will earn a commission when visitors make a qualifying purchase.

There are seven widths across the tool - which we took a closer look at in this article - some of which have a bevel:

Here are the dimensions of the Honda Special Tool 07973-4150000, used to press in or remove the main bearings on the Honda CX500, GL500, CX650 and GL650 motorcycles.

There's also an extra ring that sits around it (present in the above photo) for some of it's tasks - we don't have the dimensions of that yet but when we do we will add them to this article. On one end there's a P, the other an R:

Starting at the end marked "P" we measured the width of the tool using a Mitutoyo 103-130 outside micrometer (Amazon, eBay US, eBay CA, eBay UK, eBay AU) - #4 was out of the range of our available micrometers so we switched to the a 0-150mm digital vernier caliper (Amazon, eBay US, eBay CA, eBay UK, eBay AU), which also served to measure the length. The calipers were only able to resolve to 0.01mm, however, where the micrometer resolves down to 0.001mm - when we get a 50-75mm micrometer we will update. The measurements:

36.187mm diameter, 4.70mm height
42.860mm diameter, 20.89mm height
46.808mm diameter, 1.69mm height
51.02mm diameter, 33.16mm height
46.164mm diameter, 28.06mm height
42.861mm diameter, 20.92mm height
35.998mm diameter, 4.61mm height

The overall length of the tool is 115.062mm. The margin for error is reasonable in the height measurements due to the available device not being the most accurate!

To see the tool in use, check out the article on how to use it.