Continuing on from the previous page. Base partially cleaned up:
Two bearings under the driven pulley, 47mm OD, 24mm ID and 14mm high:
The motor mount holes are off-center:
Their off-center location makes for rather an annoying time using a socket (or even an open ended spanner) to loosen the nut. More pics during the paint removal process:
Repainting started:
The gap between the table and the table support is tiny!
This is as far as the restoration got in the time I had the press:
I didn’t get much of a chance to try it out as I only had access to the drill press for a short time, so I can’t provide much of a review. Does anyone know where this one came from?